Skip to content

Projects

Real-world electrical engineering and power systems work — from design to deployment.

Clear
Filters: Automation × 7 results
All Proteus (14) Simulation (14) Arduino (10) Automation (7) LCD (6) Sensors (5) Embedded Testing (4) PCB Design (3) Power Electronics (3) PLC (2) Renewable Energy (2) Solar Energy (1) Renewable (1) Grid-Tied (1) Installation (1) Cable Car (1) Power Systems (1) Control Panels (1) SCADA (1) MCC (1) VFD (1) Substation (1) Protection (1) Relay (1) IEC (1) Transmission Line (1) MATLAB (1) Neural Network (1) IoT (1) EV Charging System (1) Proteus Simulation (1) News Portal (1) PHP (1) MySQL (1) CMS (1) Nepal (1) Nepali Language (1) Web Development (1) Op-Amp (1) 8051 (1) GSM / SMS (1) Traffic Control (1)
Automatic railway level crossing
Proteus Simulation Arduino
Automatic railway level crossing
Automatic barriers where a railway crosses a road. With the Janakpur line running again, and more railway planned in Nepal, village roads will cross tracks in many places where a full-time gateman isn't practical. This controller closes the road for every train and opens it only when it's really…
Smart parking system
Proteus Simulation Arduino
Smart parking system
A 6-slot car park with an entry barrier, an exit barrier, and a display that always shows the real number of free spaces. It's the kind of system a municipality, hospital or shopping centre in Kathmandu could use, and it scales up by adding sensors.
Wind direction vane + turbine yaw control
Proteus Simulation Arduino
Wind direction vane + turbine yaw control
The other half of the college wind turbine idea. It reads where the wind is coming from and turns the turbine to face it. On small turbines a tail fin does this. Bigger machines, or a turbine you want to turn out of a storm on purpose, need a motorised yaw drive, and this is its controller.
DC power and energy meter with protection
Proteus Simulation Arduino
DC power and energy meter with protection
For solar panels, batteries and DC supplies. It shows volts, amps, watts and watt-hours on a 16x2 LCD and logs CSV over USB. It also switches the load off on over-voltage, over-current, a short circuit or a flat battery.
Water tank level controller
Proteus Simulation Arduino
Water tank level controller
Most houses in Nepal have the same setup: an underground sump (or a boring) and a tank on the roof. Someone has to remember to switch the pump on, and then remember to switch it off. This controller does both. More importantly, it protects the pump, because a motor running dry or against a closed…