Work
Projects
Real-world electrical engineering and power systems work — from design to deployment.
All
Proteus (14)
Simulation (14)
Arduino (10)
Automation (7)
LCD (6)
Sensors (5)
Embedded Testing (4)
PCB Design (3)
Power Electronics (3)
PLC (2)
Renewable Energy (2)
Solar Energy (1)
Renewable (1)
Grid-Tied (1)
Installation (1)
Cable Car (1)
Power Systems (1)
Control Panels (1)
SCADA (1)
MCC (1)
VFD (1)
Substation (1)
Protection (1)
Relay (1)
IEC (1)
Transmission Line (1)
MATLAB (1)
Neural Network (1)
IoT (1)
EV Charging System (1)
Proteus Simulation (1)
News Portal (1)
PHP (1)
MySQL (1)
CMS (1)
Nepal (1)
Nepali Language (1)
Web Development (1)
Op-Amp (1)
8051 (1)
GSM / SMS (1)
Traffic Control (1)
SCR latch (switching) circuit
A thyristor (SCR) latch. A short press on the trigger button turns the SCR on, and it stays on after you let go. The only way to turn it off is to break the anode current with the reset switch. That's the idea behind crowbar protection, simple alarms and "press once to start" circuits.
Op-amp LED flasher
An LM741 wired as a relaxation oscillator (astable multivibrator), running from a single 9 V battery and flashing an LED. The project includes the PCB layout with a 2-pin terminal block for the battery.
5 V regulated power supply
A linear 230 V AC to 5 V DC supply. It has a step-down transformer, a bridge rectifier made from four 1N4007 diodes, a reservoir capacitor and a 7805 regulator. I drew it three times while learning Proteus, so this folder has the simulation version and two PCB versions with the 3D view.